Data Sheet
Table Of Contents
- NKR-SWA54_User Manual_1121
- General Description
- Applications
- Ordering Options
- Features
- Revision History
- SWA54 Functional Description
- SWA54 Connector Information
- 1 Electrical, Audio and Timing Specifications
- 1.1 Module ESD spec.
- 1.2 Recommended Operating Range
- 1.3 Electrical Characteristics – DC Characteristics
- 1.4 Electrical Characteristics – RF PLL Characteristics
- 1.5 Electrical Characteristics – RF RX Characteristics
- 1.6 Electrical Characteristics – RF TX Characteristics
- 1.7 Electrical Characteristics – Audio C/CS
- 1.8 I2S Communication Interface Timing
- 1.9 I2C Master/Slave Communication Interface Timing (S_SCL, S_SDA)
- SWA54 integration manual_final
SWA54 Module Datasheet Rev 1.2
18
IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to all the
rules that apply to the product into which this certified RF module is integrated.
Additional testing and certification may be necessary when multiple modules are used.
20 cm minimum distance has to be able to be maintained between the antenna and the users for the host this
module is integrated into. Under such configuration, the IC RSS-102 radiation exposure limits set forth for an
population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate this equipment.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20 cm separation
with the antenna while this end product is installed and operated. The end user has to be informed that the IC
radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to
also be informed that any changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate this equipment. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains IC: 4441A-SWA54 ".
The Host Model Number (HMN) must be indicated at any location on the exterior of the end product or
product packaging or product literature which shall be available with the end product or online.