Installation Guide

6
□ Normal □ Internal Use ■ Confidential □ Restricted Confidential
J-Pole Installation
1
2
• Adjust pole angle to best meet base station direction.
• Tighten 2 elbow nut to fix the angle:
• Detail of the elbow screw is shown in next page.
Torque: 140 +/-10 kgf-cm
Torque: 10.12 +/-0.72 lbf-ft
• Hang the ODU device on the J-Pole
• Tightening two HEXI screw after ODE hang in place
(screw had pre-mounted with j-pole already)
Torque: 60 +/-10 kgf-cm
Torque: 4.32 +/-0.72 lbf-ft
5
Unit: mm