User's Manual

11

Wall Mounting 2.5
Refer to the steps below to mount the Access Point to a wall.
1. Place the main bracket against the installation location on the wall. Use a
pen or pencil to mark the points on the wall where the wall mounting holes
are aligned.
2. Use a power tool to drill holes in the marked locations, then insert the wall
anchors into the holes.
3. Use a power tool or a screwdriver to screw the wall mounting screws into
the wall anchors. Leave about one-third of the screw length sticking out of
the wall.
4. Align the screw holes on the main bracket with the corresponding holes on
the back of the Access point, then use four M4 screws to attach the main
bracket to the Access Point.
Note: Make sure the arrow on the main bracket is aligned so that it is
pointing toward the top side of the Access Point.
5. Align the wall mounting holes on the main bracket with the wall screws,
then hook the Access Point onto the wall screws.