User Guide

Indoor Installation (Glass Window Mounting)
Step 1: Signal scanning
Hold the Tri-band - 5G Business Internet Receiver near different locations on the wall to perform signal scanning (hold
the device at a height above your head when doing so). Once a location with good signal strength is found, the LED
on the device will turn solid white. Affix a location sticker to the spot.
Step 2: Mark the screw locations
Place the indoor bracket on the location on the wall where you want to install the device, then use a pen to mark the
locations where the screws will be drilled into the wall (as indicated in the right image below).
Note: DO NOT peel off the protective backing when installing the bracket on a wall.
Protective film