User's Manual
Table Of Contents
- Introducing the 802.11a/g Router
- Installing the 802.11a/g Router
- What’s in the Box?
- A physical look at the back panel
- A physical look at the front panel
- Connecting the Cables
- High Level Configuration Steps Required for the 802.11a/g Router
- Setting up a Windows PC or wireless client as DHCP clients
- Configuring a PC running MS-Windows 95/98/Me:
- Configuring a PC running MS-Windows XP/2000:
- Confirming your PC’s IP Configuration:
- Connecting More Devices Through A Switch/Hub To The 802.11a/g Router
- Basic Configuration of the 802.11a/g Router
- Advanced Settings
- Managing your 802.11a/g Router
- How to View the device Status
- How to View the System Log
- Security Log
- DHCP Client Table
- Wireless Client Table
- Bridge Table
- WAN Status
- LAN Status
- Upgrading Firmware
- How to Save or Restore Configuration Changes
- How to Restore the System Settings to the Factory Defaults
- How to Reboot your 802.11a/g Router
- What if you Forgot the Password?
- Command Line Interface
- Text Configuration
- Specification
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example - use only shielded interface
cables when connecting to computer or peripheral devices) any changes or modifications
not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.