User's Manual

VLANPrio5=high
VLANPrio6=highest
VLANPrio7=highest
SchedulingScheme=htb
HTBBwRatioHighest=10
HTBBwRatioHigh=20
HTBBwRatioNormal=40
HTBBwRatioLow=40
configured).
VLANPrioi (i = 0, 1, 2, …, 7): the corresponding
priority level for this VLAN 802.1p value (‘low’,
‘high’, ‘highest’).
SchedulingScheme
: the QoS scheduling scheme (‘sp’,
‘htb’).
If ‘SchedulingScheme’ is ‘htb’, the following items
could be configured:
HTBBwRatioHighest
/HTBBwRatioHigh/HTBBw
RatioNormal/ HTBBwRatioNormal: the bandwidth
percentage for the priority level
highest/high/normal/low.
[DOS]
DOSAuthenticateState=enable
DOSBroadcastState=enable
DOSPingState=enable
DOSAuthFailTimes=8
DOSBroadcastStormLevel=mediu
m
DOSPingFloodLevel=medium
DoS (Denial of Service) Configuration
DOSAuthenticateState
: whether enable
authentication failure attack (‘enable’, ‘disable’).
DOSBroadcastState: whether enable broadcast storm
prevention (‘enable’, ‘disable’).
DOSPingState: whether enable ping flood prevention
(‘enable’, ‘disable’).
DOSAuthFailTimes: if ‘DOSAuthenticateState’ is
‘enable’, this items configures the number of failures
that will put the client into the deny list.
DOSBroadcastStormLevel
: if ‘DOSBroadcastState’ is
‘enable’, this item configures the level of protection
(‘high’, ‘medium’, ‘low’).
DOSPingFloodLevel
: if is ‘enable’, this item
configures the level of protection (‘high’, ‘medium’,
‘low’).
[End] This is a dummy section that must be put at the end
of a text configuration file. There is no key and value
in this section, and any line below this section will be
ignored.
60