User's Manual

 wlan means the Wireless port;
 <> specifies the arguments of the command, <1-4> means a number between 1 to 4;
 [ ] indicates an optional parameter
 | is used to separate alternative choices of parameters or keywords;
 {} encloses all alternative keywords;
 MacAddr, or XX-XX-XX-XX-XX-XX means any MAC address in hexadecimal
format, where each XX can be 00, 01, ... 99, 0A, 0B, 0C, 0D, 0E, 0F, 10, 11,… FF;
 ipAddr, netmask, or xxx.xxx.xxx.xxx means any ip address or network mask, where
xxx is a decimal integer between 0 and 255;
 The term string means a string of characters up to the specified length, which may be
enclosed in double quotes (“) (required if the string contains embedded blanks);
 Names representing filters and MAC addresses could be up to 30 characters in length;
password and SNMP community read/write strings are up to 15 characters in length.
When the password and SNMP community write string are entered, they are echoed
back as a string of “*”s for protection, while other parameters, such as WEP keys, are
echoed back the way they are typed (in clear text).
List of Commands
From a functional point of view, CLI commands will be grouped into the following categories:
(1) System
(2) Filtering
(3) SNMP
(4) Diagnostics
(5) Security
The command format will be described in the following sections.
(1) System Commands
clear config
Description: Reset the system configuration to the factory default.
disable upnp
Description: Disable the UPnP function.
disable wlan management
46