User's Manual

installed, go to Step 8. Otherwise, select Add to install it now.
Step 4.
Step 5.
Step 6.
Step 7.
In the new Network Component Type window, select
Protocol.
In the new Select Network Protocol window, select
Microsoft in the Manufacturers area.
In the Network Protocols area of the same window, select
TCP/IP, then click OK. You may need your Win95/98 CD
to complete the installation. After TCP/IP installation is
complete, go back to the Network window shown in Step 4.
Select TCP/IP in the list of Network Components.
Click Properties, and check the settings in each of the TCP/IP
Properties window:
Bindings Tab: both Client for Microsoft Networks
and File
and printer sharing for Microsoft Networks should be
selected.
Gateway Tab: All fields should be blank.
DNS Configuration Tab: Disable DNS
should be selected.
IP Address Tab: Obtain IP address automatically
should be
selected.
Step 8. With the 802.11A+G ACCESS POINT powered on, reboot
the PC/wireless client. After the PC/wireless client is re-
booted, you should be ready to configure the 802.11A+G
ACCESS POINT. See Chapter 3.
The procedure required to set a static IP address is not too much different from the procedure
required to set to “obtain IP addresses dynamically” - except that at the end of step 7, instead
of selecting “obtain IP addresses dynamically, you should specify the IP address explicitly.
13