Owner`s manual

15.1 Your bike has been fitted with a quick release handlebar clamp that allows
you to change the position of the bars quickly and easily to find the most
comfortable riding position.
15.2 The stem and handle bars need to be fitted before you use the bike.
15.3 To fit, insert the stem into the front tube at least to the position of the
“Minimum insertion” mark.
15.4 Tighten the quill bolt and fix stem.
14.5 Push in the direction of the arrow slide cap 1 and lift lever 2.
15.6 Adjust stem to preferred angle and lightly tighten BOLT 1 then BOLT 2
to a suitable position so that the slide cap 1 will fit when locked, then press
down lever 2 to lock the handle bars in position.
15.7 Test the bars to make certain they are tight and do not rotate. If they are
not tight enough, release lever 1, lift lever 2, adjust BOLT 2 again then
press down lever 2. Repeat until the handle bars are tight and safe.
IMPORTANT when fitting always adjust Bolt 1 first so the body and
cap touch then Bolt 2.
16 The front connection box
16.1 The front connection box allows for the easy removal for repair
or replacement of any of the electronic components on the
handle bars. Please ensure no wires are trapped between the two
halves when reassembling and do not over tighten the 4 screws.
17 Quick release saddle height adjustment
17.1 Your Wisper bike has been fitted with a quick release saddle post collar to
facilitate the movement of the saddle to remove the battery or to change
the riding position. Always ensure the collar is fully engaged on the seat
tube.
17.2 It is important that the nut on the collar is tightened so the post will be
gripped in the bike tube firmly. Make this adjustment with the quick
release lever in the open position.
17.3 Adjust the seat to the correct height and close the lever. When you sit on
the saddle there should be no vertical movement at all in the saddle post.
IMPORTANT never raise the saddle past the point where the maximum marks on
- 17 -