Owner`s manual

you have turned the bike “off”. When the bike is “off” you will not get any
assistance from the battery and motor and the bike is effectively simply an
unpowered push bike. To turn the power back on so the pedelec and
throttle work again simply press the ON/OFF button once, the capacity
indicator will illuminate showing the power is on.
10.3 How to adjust functions:
10.3.1 How to adjust the pedal assistance. Refer 12.2, 12.3 and 12.4
paragraphs.
10.3.2 How to adjust the back light of the LCD. Press the “set” button
once, you will see a light symbol added under the battery
capacity indicator, then press the “up arrow” to turn the back light
on. The more times you press the brighter back light you will get.
Refer to above picture.
10.3.3 How to read the single trip distance. Press the “set” button twice;
you will see a symbol in the left side of the screen.
10.3.4 How to read the single trip riding time. Press the “set” button three
times; you will see a clock symbol in the left side of the
screen. This display does not provide the time of day – simply
elapsed riding time since last reset.
11The LIGHTS
11.1 The front light is an automatic sensor light.
When you turn the power on, it checks the
brightness of the surroundings. It will light
when you ride the bike in low light
conditions. It will turn off after 30 seconds
when the ambient light increases.
11.2 The rear light is also automatic. The sensor
point is from front light.
12 Pedelec mode and ASSIST
mode
- 12 -