Owner`s manual

- 8 -

from the battery. It is possible that the battery will take up to 12 hours to charge on

the first three charges.

4.2 Always charge the battery always in a well ventilated area.

4.3 Do not leave the charger connected to the mains when not in use.

5 Water

5.1 Your electric bicycle is rain and splash proof.

5.2 The electrical components of the vehicle, such as motor, battery, and controller,

must not be submerged in water.

6 Maintenance and adjustments

6.1 IMPORTANT! Do not attempt to open the casings of the battery, motor or

controller it could be dangerous and all warrantees will become void. If you

experience a problem contact our service department or your retailer.

6.2 Wheel spokes should be adjusted after 300 kms of riding. Saddle tube should never

be raised beyond the maximum indicated by a safety line around the tubes. The

recommendation of the torque on the nuts as follows:

(A) Front axle nuts. 70N.M

(B) Back axle nuts. 46N.M

(D) Seat pillar clamp nut/bolt. 5-8N.M

(E) Brake cable anchor bolt. 5N.M

(F) Brake centre bolt. M6:11N.M

(G) Seat clamp nuts. 24N.M

(H) Cotter pin nuts. R:42N.M L: 46N.M

(I) Gear shifter nuts. 4N.M

(J) V brake caliper nuts. 10N.M

(K) Rear carrier nuts. 8N.M

(L) Mudguard bracket nuts. 8N.M

Other nuts/bolts torque depends on their size. M4:2.5-4.0N.M5：M5:4.0-6.0N.M

M6:6.0-7.5N.M

6.3 Your bike has a rear derailleur that will automatically tension your chain. However

if the chain becomes loose or frequently comes off the drive wheel, you can easily

adjust the chain tension by loosening the rear axle nuts slightly, and adjusting the

tension bolts. Make sure that the chain runs freely and re-tighten the axle nuts.

6.4 The brake levers should lock the wheels when compressed half way between their

open position and touching the handle bars.

6.5 Warning: Handlebar hand grips or tube end plugs should be replaced if damaged,

as bare tube ends have been known to cause injury.

6.6 Warning: Any replacement forks must have the same rake and same tube inner