Product Guide

Charging Instruction
• This product adopts the gravity type buckle design. The
mobile device is placed on the bracket, and the le and right
arms will clamp the mobile device inward under the force of
gravity. The bottom support feet of the bracket can be
adjusted up and down to accommodate dierent sizes of
mobile devices.
• This product has two installation methods, snap-on and
suction-cup type, the assembly method is shown in the
attached figure. The connection between the bracket and the
support portion adopts a universal ball method and can be
adjusted in various directions.
• Connect the wireless charger to the wall charger or USB port
by its charging cable.
• Put the mobile device on the wireless charger, make sure
your device is centered on the wireless charger.
• Unplug all connections aer use.
 Model: TX21
PRODUCT GUIDE
120 mm
150 mm
Wireless Charger
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
Use of an attachment not recommended or sold by the battery
charger manufacturer may result in a risk of fire, electric shock, or
injury to persons.
Caution
• Always keep the unit dry and avoid exposure to even light
moisture.
• Keep away from fire, direct sunlight and extreme heat.
• Do not disassemble or reassemble the charger.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
• Store the product out the reach of children and in a dry and
dust-protected ambience when not in use.
Step 1
Or
S
t
ep 1
Step 2
Basic Specification
• Input: QC 5V/2A, 9V/1.67A
• Output: DC 5V/1A, 9V/1.1A
• Power: 10W
• FCC ID: 2AT58TX21
Note: This product is RoHS compliant.