Quick Start Guide

P a g e | 6

WISER Systems, Inc. 819 W Hargett St

www.wisersystems.com Raleigh, NC 27603

1.1.1 Temporarily Attaching to Wall

Antennas can be temporarily attached to walls as well. For best performance, the devices

need to be oriented with the flat underside of the Antenna head facing the floor.

To achieve this, rotate the stem of the device 180 degrees relative to the base as shown in

the images to the left. Then, the device can be attached to a wall somewhat like is shown:

1.1.2 Tracker Tags

Each WISER Tracker Tag included is ready for immediate use after basic assembly.

First, place the battery in the battery clip on the on the PCB board of each tag to be used.

Be sure to insert the coin cell battery positive (+) side away from the chips. Inserting the

battery incorrectly may cause damage to the tag.

The WISER bullseye logo is found on the top half of the tag enclosure. Place the printed

circuit board (PCB) down into the three cradles in the top half of the tag enclosure, with

the battery fastener facing up. Then snap the bottom half of the enclosure shut to secure

the PCB.