Quick Start Guide

P a g e | 10

WISER Systems, Inc. 819 W Hargett St

www.wisersystems.com Raleigh, NC 27603

iii. In the menu, select Configure Devices → Discover Network. You will receive a

message that says, “Found X Antennas.” Verify that the system has detected each

USB or wireless device and that the short IDs match those detected.

iv. If not all your Antennas appear, make sure all devices are powered and that each

Antenna is in communication range with at least one other Antenna.

v. Antenna icons should now appear on your map in the application. Using the

mouse, left click and hold on the dots at the center of each icon and move them to

the location that roughly reflects their position in the physical environment to be

tracked. Do this for each individual icon.

vi. Finally, set the height of each Antenna to prepare for system calibration. To set

Antenna heights, right click each individual Antenna or hover the cursor over an