User's Manual

Wisen Innovation Technical Doc. No.2021 WiSenMeshWAN® Voltage Interface Node - User Manual
www.wisencn.com Page - 8 - of 13
4. Terminologies
Figure 3. Voltage Interface Node Internal Configuration Terminologies
5. Operation Procedures
5.1．System Deployment Notifications
1) Location: The deployment location of a Voltage Interface Node is usually determined by the required monitoring
or inspection location;
2) All the Serial Numbers of a Unit must be recorded against their site references;
3) Before any Voltage Interface Node is switched on, two tasks will need to be carried out:
A. Unlike the Tilt Node which has a MEMS tilt sensor embedded in the node, the Voltage Output sensors
chosen by the customer must be connected to the Voltage Interface Node;
B. The connections between a customer chosen Voltage sensor and a Voltage Interface Node must strictly
follow the rules stated in this document;
C. A gateway must be deployed, powered on and proven to be working properly. Otherwise, the nodes will
need to be switched off, then switched on again after a gateway is switched on. So simply speaking, the rules