User's Manual

Wisen Innovation Technical Doc. No.2021 WisenMeshWAN® Enhanced Omni Tilt Sensor Node - User Manual
www.wisencn.com Page - 10 - of 13
Figure 4. Axis marks on the product label.
5.3．Deployment Procedures
1) Open the box: Take the node out of the package and open its lid;
2) Insert Battery: By default, a node does not contain a D-Cell battery. Therefore the battery needs to be inserted.
Notice : +ve and –ve orientation must be correct, otherwise, the internal circuit may be damaged;
3) Antenna Installation: Screw the antenna firmly onto the node;
4) Power On: turn the switch to the ON status. After that, you will see: 3 LEDs flashing for 3 times, then green LED
on for 1s, then 3 LEDs quickly flashing once, and finally all 3 LEDs are completely turned off to save battery power
while a node is running. Switch off the node to save power if the gateway is off;
5) Tighten the 4 Cap-Hex-Head screws of the lid to secure the enclosure IP rating;
6) To validate the sensor data, please visit Wisen Visualisation Platform for further details.
5.4．Mounting Options
The node fixings must be rigid for the sensor to measure accurate data. Movement in the fixings will affect the
readings;
The Enhanced Omni Tilt Sensor Node must be oriented with any two axis marked on the label parallel to the horizontal
plane, so that the data can be easily interpreted.
6. General Maintenance and Notification
1) Once a Tilt Node is installed in the field, please minimise any man-made disturbance so that data
quality can be maintained;
2) Radio communication will be impaired if the antenna is covered by metal or very moist soil material;