User's Manual

Wisen Innovation Technical Doc. No.2019 WISENMESHNET® L-Series VW Interface Node - User Manual
www.wisencn.com Page - 8 - of 14
4. Terminologies
Figure 3. VW Interface Node Internal Configuration Terminologies.
5. Operation Procedures
5.1．System Deployment Notifications
1) Location: The deployment location of a VW Interface Node is usually determined by the required monitoring or
inspection location;
2) Before any VW Interface Node is switched on, two tasks will need to be carried out:
A. Unlike the Tilt Node which has a MEMS tilt sensor embedded in the node, the VW sensors chosen by the
customer, e.g., VW crackmeter, VW settlement gauge, VW strain gauge, etc, must be connected to the VW
Interface Node;
B. A gateway must be deployed, powered on and proven to be working properly. Otherwise, the nodes will
need to be switched off, then switched on again after a gateway is switched on. So simply speaking, the rules
to follow to correctly deploy a WISENMESHNET system are: