Operating Guide

WiseLift

NOTE: Complete visual walk-through of table assembly is available at

https://www.youtube.com/watch?v=NY_qzg-u_rw&t=6s

NOTE: If you discover a problem at any point during the setup and positioning of your lift table,

stop and contact a WiseLift representative at 1-877-782-2010. To avoid personal injury and/

or product damage, do not plug the unit into the electrical outlet until the problem is corrected

and do not attempt to fix electrical problems by yourself.

The WiseLift Table base has 3 position options. If you are using the wheels, for rolling the

table around, only the center position is used for maximum stability. For fixed locations with a

sofa or lift chair, the left or right positions accommodate either left or right side configurations.

This puts most of the base under the furniture for maximum support and low profile.

The WiseLift Table will be shipped to you in 3 main pieces, the table base, column and top.

It is recommended that you place these peices on the floor in the orientation shown in

Figure 1.1. To assemble the WiseLift Table, follow these instructions:

1. Stand the Base on its side (fig. 1.1)

2. If you intend on using wheels, install them in each corner of the base. Screw them in

hand tight and then finish with the provided crescent wrench.

3. Install column in desired port (center port if using wheels)(fig. 1.2)

ASSEMBLY

Figure 1.1