Full Product Manual

WiseLift
8
6. Ensure that the power supply cable and remote cable (green cable markers) are
properly attached to the base connectors. These will come pre-connected. Secure the
remote cable at the base of the chair to the preferred armrest side with the adjustable
cable clip (Figure 1.2c). This will ensure that the remote cable doesn’t disconnect
7. Check to see if the chair is stable in its final location. If the chair seems unstable or
wobbly, adjust (Figure 1.3) the foot pads by turning them to raise or lower pad.
BATTERY INSTALLATION
Your lift chair is equipped with a battery backup system (figure 1.4) that will activate during a
power failure. The backup system is powered by two 9V batteries that need to be installed into
the external transformer. Follow these steps to install the batteries:
1. Unplug the external transformer power cord from the electrical outlet (surge protector).
2. Open the marked battery door on the external transformer.
3. Install two 9V batteries into the external transformer.
4. Replace the battery door.
5. Plug the external transformer power cord back into the electrical outlet (surge
protector).
NOTE: If you unplug your lift chair for an extended period of time (more than one hour),
remove the batteries from the external transformer. THE LIFT CHAIR WILL DRAW POWER
FROM THE BATTERIES EVEN WHEN IT IS NOT IN USE.
Figure 1.2a
Figure 1.2b
Figure 1.2c