Manualshelf

User's Guide

ManualsBrandsWise Ally Holding ManualsElectronicsRapid Response Button
12
Reserved
for back
image of
the Device
(1) Lanyard Ring
(2) Left Button
with LED
(4) USB Port
and Reset Pin
(5) Recessed
Area for Badge
(3) Right
Button
(6) Device Label
(4b) USB Charging Port
(7) USB Charging Cable
(1)
Lanyard Ring
Attach lanyard with the ring to wear the device
(2)
Left Button with LED
The left button is smooth and translucent with
LEDs inside it
(3)
Right Button
The right button is blue and textured
Trigger / Stop Alerts
Press and hold both the left button and the right
button to trigger alerts and location reports. The
LED will flash when an alert is triggered.
Press and hold both buttons again to stop alerts.
Silent / Audible Alert Mode
When the silent alert mode is triggered, the
device will vibrate once and the LED will flash
green. Once a location report is sent, the device
will vibrate.
When the audible alert mode is triggered, the
device will beep and the LED will flash red. Once
a location report is sent, the device will vibrate.
If an alert is triggered and not stopped,
the device will send a location report
every one minute
Check Silent / Audible Alert Mode
Press and release the right button. If the
LED flashes green, the device is in the
silent alert mode. If the LED flashes red,
the device is in the audible alert mode
Switch Between Silent / Audible Alert
Modes
Press and hold the right button for 3
seconds to switch between silent /
audible alert modes
The device will beep and flash green LED
when it is switched to the silent alert
mode
The device will beep and flash red LED
when it is switched to the audible alert
mode
(4)
USB Port and Reset Pin
(4a) Micro USB Port for charging and
device update (by device managers)
(4b) Reset pin. Device can be power
cycled by pressing the reset pin with a
paperclip
(5)
Recessed Area for Badge
Optionally stick an employee badge
photo in the recessed area
(6)
Device Label
●
DevEUI:
LoRa Device Extended
Unique Identifier
●
Address:
Device MAC address
●
Serial No.
Device serial number
●
FCC ID:
Device FCC ID
●
QR Code:
Scanning of the QR code
renders a concatenated DevEUI,
Address and Serial No.
(7)
USB Charging Cable
Charging Micro USB cable for the device
Device Specs:
Model:
AP82
Radio Frequency Band:
900MHz Band
WiFi Band:
2.4GHz
Bluetooth Version:
4.2
Dimensions:
2.6 x 4.5 x 0.4 inch
Weight:
62g
Battery:
500mAh
Operating Temperature:
0-45C
Relative Humidity:
0-95%
(4a) Reset Pin
The Rapid Response Button is designed to improve employee safety by providing indoor location information of
employees upon emergency leveraging PwC’s Indoor Geolocation Platform (IGP).
Rapid Response Button User Guide

Summary of content (2 pages)