Owner`s manual

33
TheZoneCongurationscreenallowsyourinstallertoreassignspecicchannels
toeitherasecondorathirdzone,usingtheradiobuttonsandpulldownmenus.
Inthiscase,forexample,yourinstallermightchangechannels5and6toLeft
andRight,respectively,andputchannels5,6,and9intoZone2.Thiswould
giveyoua5.1systemforyourmaintheaterthatusestheLeft,Center,Right,and
SurroundoutputsalongwithSubwoofer1,whilethesecondzoneutilizedthe
“Back”channelsandSubwoofer2.
ThisZoneCongurationprocessiscritical,sinceitdeneswhenthespeak-
ersare“chirped”formeasurements.TheSC-1will“chirp”allofZone1and
thenpausetoallowyourinstallertomovethemicrophonetothesecondzone
beforeresumingwiththemeasurements.
Similarly,youcouldhavethree2.1systemssetuponasingleSC-1.Select“6.3
Phantom”ontherstscreenofSystemConguration,andthensetupasfol-
lows:
• Zone1=Left,Right,Subwoofer1
• Zone2=LeftSurround,RightSurround,Subwoofer2
• Zone3=LeftBack,RightBack,Subwoofer3
Usingthe“6.3Phantom”optionskipstheCenterchannelentirely,whichisnot
strictlynecessary,butissimplerwhentryingtorememberwhichchannelis
beingusedinwhichroom.
Thenextseveralscreensallowtheinstallertorecordcertaininformationabout
theinstallation,includingJobInformation,selectionofacalibratedmicrophone,
RoomDimensions,andEquipmentinformation.Yourinstallerwillcomplete
theseformssoastodocumenttheinstallationproperly,andthenmoveonto
themeasurementsofyourroom.
Job Information
OnceyoureachtheJobInformationscreenshownabove,youcansafelycon-
nectthemicrophonetotheSC-1.
Ingeneral,however,wesuggestwaitinguntilyoureachtheMeasurement
screentoconnectthemicrophone,sincethisistheonlyscreenintheapplica-
tionthatactuallyrequiresthemicrophone.ButonceyoureachtheJobInforma-