User manual

are connected well, then power can be applied to the device. The main socket and fuse are
located at the rear panel of the device.
When the device is powered on, verify that the display shows the following message:
Digital TV Processor (factory default unit-name)
IP: 10.10.60.148 (factory default IP Address for LAN access)
If no message is shown in the display or there is not light in the display, the device is
defective and has to be returned for servicing.
4. Navigating the Front Panel
POWER Power indicator, green light means power is OK
TUNER LOCK Tuner lock indicator, green light means signal is locked; if
there is no light, which means no signal input or wrong
parameters setting.
ALARM Alarm indicator
LCD 2 × 20 character LCD
Operation buttons
〕〔 〕〔 〕〔 〕〔
ENTER
〕〔
EXIT
buttons
〕〔
are used to up/down pages of menu or
increase/decrease value when edit numbers
〕〔
are used to move cursor
ENTER
is used to enter sub menu or confirm operation
EXITis used to return previous menu or cancel operation
Common Interface PCMCIA Module slot
5. Menu Structure and Operating the Device
The menu structure of the device is showed in below figure. After initialization is completed,
press ENTER button to enter main menu:
Main Menu
Inputs
Outputs
Ethernet
System