User manual

Video Format
Output port
Resolution
SDI port
576I25 ,480I29.97, 1080I25, 1080I29.97, 1080I30
HDMI port
576I25 ,480I29.97,480P60, 576P50, 720P50,720P59.94 720P60,1080I25, 1080I29.97,
1080I30
YPbPr port
576I25 ,480i29.97,480P60, 576P50, 720P50,720P59.94 720P60,1080I25, 1080I29.97,
1080I30
CVBS port
576I25,480I29.97
3. Installation
3.1 Inspection
Open the packaging box, check if all appendixes are in the box according to the
appendix list, and if the device has any visible damage, please contact the agent.
3.2 Operating Voltage
Do not connect AC power until you have verified that the line voltage is correct and the
proper fuses are installed. The device‟s power supply is fitted with a wide-ranging power
supply. It is suitable for supply voltages of 100-240 Vac -10% +6% at 50/60 Hz nominal. Be
sure the supply voltage is within the specified range.
POWER REQUIREMENT
Input voltage
90-250 Vrms auto select
Frequency
47 to 63 Hz
Power
50 VA max. / 30 VA typical.
Current
110 V/0.27A or 240 V/0.125A typical
3.3 The fuses
The recognized recommended fuses are size 5 by 20 mm, rate T 2.0A, 250 V (UL and
IEC approved).
The line fuse is housed in a small container besides the power connector on the rear
panel. To check the fuse, insert the tip of a screwdriver in the slot at the middle of the
container and pry gently to extend the fuse where there is a little tap and pull out the fuse
gently. The fuse is attached to the line module and cannot be removed.
3.4 Connecting Up the Device
Always use the specified cables supplied for signal integrity and compliance with EMC
requirements.
The rear panel is directly related to the input and output options fitted. Below figure
shows a typical rear panel.