User manual

TS Bit Rate  set to the bit rate of incoming stream in experimental test, this value will be
ignored by 5000P if “Output Smoothing = Auto” in previous step.
4. After previous steps, 5000P will capture the incoming IP stream immediately. Normally it
takes 30-60 seconds to lock the stream. You can go to the Main menu  inputs  Status
IP IN to check the bit rate of incoming stream.
5. Finally, if user wants to watch TV decoded from IP incoming stream on the output of 5000P,
don‟t forget to set the decoder portion of 5000P to select IP as the program source.
9.2 How to set the Unicast/Multicast output
If the IP hardware board is configured as IP Input, please follow below procedure to change it to
IP output:
1. Only on the front panel is accessible, go to
Main Menu  System  Optional function  External board type  IP Out
2. Switch off the unit, and then switch it on again. Then the unit will become IP Out, and the
FACTORY DEFAULT setting will not change this IP direction. And at the same time, the
menu structure on front panel & HDMS (the PC management software) will be changed
accordingly.
To set Unicast/Multicast output, please follow the procedure below:
1. Go to the Main menu  Outputs  Ethernet
2. Set the IP address & parameters for the IP hardware board:
Stream IP addr  enter the IP address for this IP hardware board (should be the same
network section of the Stream Gateway, this depends on the characteristic of the gateway)
Stream Netmask  enter the network submask for this IP hardware board
Stream Gateway  enter the Gateway address for this IP hardware board
Stream MAC addr  Show the MAC address of this IP hardware board, read only.
3. Set the universal parameters for the output IP stream. On the same sub menu:
Gate MAC Address  here the MAC address must be set as the as the MAC address of the
Gateway where 5000P is located.
Protocol  enter the protocol of the output stream, 5000P supports UDP and RTP.
TS Pkts Per UDP  set the quantity of TS packages that will be carried IP package. The
range goes from 1 ~ 7
Time to Live  set the TTL for the output IP package.
Type of Service  set the type of service for the output IP stream
Source set the wanted stream output via IP.
Mode Set the IP output mode as IPTV mode or DVB mode.
4. If the mode is set to be DVB mode, please follow below procedure „DVB mode‟. If the mode is
set to be IPTV mode, please go to procedure „IPTV mode‟ directly.