User manual

5000P-xx 1pc
CD 1pc
User Manual 1pc
Power Cord 1pc
RCA A/V Cable 1pc
BNC Cable 1pc
RS232-to-XRL cable 2pcs
9. IPTV Configuration Quick Guide
First of all, make sure that your unit is equipped with IP hardware board. If not, please contact
your agent for information.
9.1 How to receive a multicast or unicast stream
Normally, the 5000P is set to IP Output by the factory. To set the 5000P to IP input mode, please
follow the procedure below:
1. Only on the front panel is accessible, go to
Main Menu  System  Optional function  External board type  IP in
2. Switch off the unit, and then switch it on again. Then the unit will become IP in, and the
FACTORY DEFAULT setting will not change this IP direction. And at the same time, the
menu structure on front panel & HDMS (the PC management software) will be changed
accordingly.
To receive a multicast/unicast stream:
1. Go to the Main menu  Inputs  Ethernet
2. Set the IP address & parameters for the IP hardware board,
Stream IP addr  enter the IP address for this IP hardware board (should be the same
network section of the Stream Gateway, this depends on the characteristic of the gateway)
Stream Netmask  enter the network submask for this IP hardware board
Stream Gateway  enter the Gateway address for this IP hardware board
Stream MAC addr  Show the MAC address of this IP hardware board, read only.
3. Set the parameters for the incoming IP stream. On the same sub menu:
Multicast IP addr  enter the multicast IP address for the incoming stream (for the addresses
inside 224.0.0.1 to 239.255.255.255 are belonging to multicast, for others else are belonging
to unicast, the 5000P will identify it automatically)
Multicast UDP port  enter the port number of the incoming stream
Protocol  enter the protocol of the incoming stream, 5000P supports UDP and RTP.
Output Smoothing  Clock recover method from IP incoming stream, MUST set to
Auto (both Auto & Fixed rate are for experimental test only).