User manual

transport stream over IP.
Uni/Multicast UDP port: Enter the UDP port number of the TS over IP stream.
ProMPEG FEC: Enable/Disable: Enable or disable ProMPEG FEC function.
Column FEC UDP port: you can set Column FEC UDP port number
Row FEC UDP port: you can set Column FEC UDP port number
Mode(1D:column, 2D:row+column, 5X5: the size of matrix)
1D ， 5X5 Support packet loss : 5/1000package
1D ， 5X20 Support packet loss :20/1000package
1D ， 10X10 Support packet loss :10/1000package
2D ， 5X5 Support packet loss :5/1000package
2D ， 5X20 Support packet loss :20/1000package
2D ， 10X10 Support packet loss :10/1000package
FEC Alignment: you can select from Annex A or Annex B
Note: only when this option is enabled and the IP Out protocol is set to RTP, the
following options are valid.
5.4.2 IP In
IP in status: you can check the IP In status of the unit in this option.
RTP/UDP: it will display the transport protocol.
Column FEC;Row FEC: it will display the Column FEC and Row FEC value.
Both value will be less than 20.
Packets per UDP frame: it will display Packets per UDP frame.
Received TS frames: it will display the TS frames received by the IP port. The
value is accumulated.
Fixed RTP frames: it will display the Fixed RTP frames.
Note: Above sub-menus only appear when the IP in status is set as Locked.
Uni/Multicast Address: Enter the IP address of the multicast stream for the
transport stream over IP.
Uni/Multicast UDP port: Enter the UDP port number of the TS over IP stream
Column FEC UDP port: Enter the Column FEC UDP port number
Row FEC UDP port: Enter Row FEC UDP port number
TS clock recovery: Select the TS clock recovery mode from Auto or Fixed rate.