User manual

Mux Switch: the internal multiplexer could be switched On/Off. The default value is „off‟.
To activate the re-Multiplexing function, you should turn on this Mux functional block.
Bit Rate: should be set to a specified value that doesn‟t exceed the Maximum physical
limit of the output medium. For example, to deliver the multiplexed TS to an 8MHz DVB
256QAM modulator, it should not exceed 55000Kb/s, otherwise overflow occurs.
TS ID: you can configure the TS ID to mark the multiplexed TS. Default value is 1.
Program List: press the <ENTER>-key to enter „Mux List‟ sub-menu. It shows all
programs detected by DCH-5000P. The programs could be come from ASI input, Tuner,
TS/IP input or the internal CI de-encryption block. Use < > < >-keys to roll up the
program names, and use < > < >-keys to switch among input sources, where a
number in front of the program name indicates the input source:
0-xxxxx displays the program name, which comes from ASI input.
1-xxxxx displays the program name, which comes from TUNER input.
2-xxxxx displays the program name, which comes from TS/IP input
3-xxxxx displays the program name which comes from the CI.
4-xxxxx displays the program name, which comes from ASI2 input.
5-xxxxx displays the program name, which comes from BISS De-encrypted
input.
On „Program List‟ sub-menu, on the first row, all encrypted programs are labeled with a
„$‟ sign. All programs that are being selected to be re-multiplexed are labeled as „Pass‟,
otherwise, the un-selected programs are labeled as „Fobrid‟. Use <ENTER>-key to
selected or un-selected the program being shown.
When leaving the „Program List‟ sub-menu, a new menu will be shown „Confirm
changed?‟ Press <ENTER>-key to validate all programs just be selected to be
multiplexed or to scrap by pressing <EXIT>-key.
After a few seconds, the multiplexed TS will be generated and delivered to the specified
destination(s).
5.2.8 Ethernet
(Note The Ethernet menu is showed only if the unit is a Megabit model, on which IP
streaming in/out board is installed and the TS/IP streaming board is set to “IP Out”. Refer to
section 5.3.6)
The TS/IP Ethernet connector could also be configured as the output of the transport
stream over IP. The parameters listed below must be set to appropriate values for the
network over which the transport stream over IP is broadcasted.
Stream IP Addr: Enter the IP address for streaming IP output of the unit.