User manual

press <EXIT>-key to scrap.
Setup: under this sub menu, you can see all program names from the source of CI that
was set in „CI Source‟ previously. All free programs are marked with „Free‟ in the first
row.
To select which program to be de-encrypted, press the < > or < >-key to roll up and
down the program names and press <ENTER>-key to change the status of the
corresponding program (only encrypted program could be selected). Three different
statuses could be set:
Slot 1 (de-encrypted with upper CAM inserted)
Slot 2 (de-encrypted with lower CAM inserted)
Bypass (no de-encryption).
The status will be shown in the first row on the LCD display. Confirm this setup when
leaving this sub menu, press <ENTER>-key to save or press <EXIT>-key to scrap.
The de-encrypted program could be delivered to other functional blocks, like A/V
decoder, ASI1, ASI2, SDI, Mux and TS/IP output (refer to section 5.2.3~5.2.8 for more).
CAM name: under this sub menu, you can see the names of CAM modules.
5.2.3 Decoder
You can configure the parameters of Video and Audio of the program decoded by AV
decoder.
Status: OK or Alarms indicates the status of the decoder. You can use the
<ENTER>-key to check detailed information.
Source: Press the <ENTER>-key and use the < > or < >-key to roll up or down to
select the signal source of ASI output, there are 5 type of signal source optional:
CI De-encrypted: the de-encrypted transport stream from CI functional block
will be delivered to the ASI output port on the back panel.
TUNER: the transport stream from Tuner block will be delivered to the ASI
output port on the back panel.
ASI1 Input: the transport stream comes from ASI1 input port will be delivered
to the ASI1 output port on the back panel.
ASI2 Input: the transport stream comes from ASI2 input port will be delivered
to the ASI2 output port on the back panel.
Mux TS: the transport stream comes from internal Mux functional block will be
delivered to the ASI output port on the back panel.
(The Mux TS is valid only when the Mux function block is enabled and turned
on. Refer to section 5.2.7 and section 5.3.6 for how to set the Mux function
block.)
Press <ENTER>-key to save or press <EXIT>-key to scrap. A few seconds after the