User Guide

Capturing Live Network Data
63
on the target. Once installation is completed go to the Services control panel, find the Remote Packet
Capture Protocol service and start it.
Note
Make sure you have outside access to port 2002 on the target platform. This is the port where
the Remote Packet Capture Protocol service can be reached, by default.
To access the Remote Capture Interfaces dialog use the "Add New Interfaces - Remote" dialog, see
Figure 4.8, “The "Add New Interfaces - Remote Interfaces" dialog box”, and select "Add".
4.8.1. Remote Capture Interfaces
Figure 4.9. The "Remote Capture Interfaces" dialog box
You have to set the following parameter in this dialog:
Host Enter the IP address or host name of the target platform where
the Remote Packet Capture Protocol service is listening. The drop
down list contains the hosts that have previously been successfully
contacted. The list can be emptied by choosing "Clear list" from the
drop down list.
Port Set the port number where the Remote Packet Capture Protocol
service is listening on. Leave open to use the default port (2002).