Installation Manual

page | 8
FRONT AND REAR PANEL DESCRIPTIONS
Front panel
A. Power LED light bar: Blue is at its highest intensity on the left side of the
light bar.
• Blue LED on = Amplifier is active or in standby mode.
• Blue LED off = Amplifier power is off.
B. SUB (LFE) channel LED: Displays the status for sub out.
• Blue LED: LFE signal has been decoded (is present), and audio is being
sent to the subwoofer line out.
• LED off: LFE signal is not present.
C. Speaker channel LEDs: Indicate the amplifier’s operating state. Each
channel has one bi-color LED.
• Blue LED: Amplifier is on and functioning properly.
• Red LED: Amplifier is on and is
not functioning properly. Check for
possible short at speaker output.
• LED off (when power LED is blue): Amplifier channel is off.
D. Input LED: Blue LED displays the active input source.
• Blue LED: The input source is active.
• LED off: The input source is inactive.
E. Decoding LED: Displays the status for Dolby/DTS decoding.
• Blue LED: Dolby/DTS input signal is decoding.
• LED off: No Dolby/DTS signal is being received via input.
F. Power button:
• Press and release (momentary) to turn on or put it into Standby mode.
• Press and hold for 10 seconds to put it into deep Standby mode (<0.5W).
A B C D E F