Installation Manual

page | 6
USA Compliance
FCC Part 15, Subpart B & IC Unintentional Emissions Interference
Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Cet appareil est conforme à la section 15 des règles. Son utilisation est soumise
aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d’interférences
nuisibles et (2) cet appareil doit accepter toutes les interférences reçues, y
compris celles pouvant entraîner un fonctionnement non souhaité.
MPE Requirements：
To satisfy FCC / IC RF exposure requirements, a separation distance of
20 cm or more should be maintained between the antenna of this device
and persons during device operation.To ensure compliance, operations at
closer than this distance is not recommended.
Les antennes installées doivent être situées de facon à ce que la
population ne puisse y être exposée à une distance de moin de 20 cm.
Installer les antennes de facon à ce que le personnel ne puisse
approcher à 20 cm ou moins de la position centrale de l’ antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout temps
éloigné d’au moins 20 cm des personnes pendant son functionnement.
Canada Warning Statement
CAN ICES-3 (B)/NMB-3(B)
• This product meets the applicable Innovation, Science and Economic
Development Canada technical specifications.
• Ce produit répond aux spécifications techniques applicables à l’innovation,
Science et Développement économique Canada.