Installation Manual
page | 18
Configuring the default power on settings
• Power On Input: Determines which input is selected automatically when
the amplifier is turned on.
• Power On Sound Mode: Determines which sound mode is selected when
the amplifier is turned on.
• Note: Sound mode selection applies only to audio content that is not
Dolby/DTS. If the amplifier receives a Dolby/DTS signal it, will decode
and output Dolby/DTS.
• Power On Volume: Determines the volume level of the amplifier when it
is turned on.
Configuring the CEC settings
• CEC can be enabled or disabled on the amplifier for Power On, Power Off,
Source selection, and Volume control.
• HDMI CEC (consumer electronics control) is a feature that allows
compatible devices to be controlled from a single remote control. For
details, refer to your TV’s instruction manual.
Configuring Standby mode and HDMI pass-through
Network Standby on: Enables the standby feature for the amplifier.
• RJ45 port is connected: The amplifier will go to networked Standby
mode without any signal input for 15 minutes.
• RJ45 port is disconnected: The amplifier will go to Standby mode
without any signal input for 15 minutes.
Network Standby off: disables Standby for the amplifier.
HDMI Audio Out: Determines whether the audio signals from the
connections HDMI1, HDMI 2, and HDMI3 are also looped through to the TV
set.