Installation Manual

page | 17

Main functions

1. Adjust the Speaker Setup parameters for each channel, including speaker

size, crossover, slope, speaker level, and test tone.

• Speaker size: You can set the size of the speakers according to your

speaker system. Large and Small are the two options for the Front Left,

Center, Front Right, Surround Left, and Surround Right speakers. On and

Off are the two options for the Subwoofer output.

• Crossover: With the crossover frequency, you define the frequency up to

which the subwoofer should be active.

• Slope: With the slope setting, you can set the frequency rolloff

(steepness) of the crossover filters. Options include 6, 12, and 24 dB per

octave. Lower values result in a more gradual rolloff, and higher values

result in a more agressive rolloff.

• Speaker Level: Set the relative volume within a range from –10

(decrease) to +10 (increase) for each speaker.

• Distance: Speakers are usually located at different distances from the

listening position, which may compromise the surround sound effect.

Here, you can set a slight delay of the signal to compensate these

differences for all channels. Measure the distance from the listening

position to the speakers and enter these values in the menu. The system

calculates the required delays to each channel.

• Test signal: You can activate and deactivate pink noise as a neutral test

sound.