Installation Manual

page | 16
Basic operation
1. Set the volume gain for different input through level trim bar.
2. Select the sound mode for current input:
Note: Sound mode selection applies only to audio content that is not
Dolby/DTS. If the amplifier receives a Dolby/DTS signal, it will decode and
output Dolby/DTS.
• 2ch Stereo: Stereo only via front left/right and subwoofer
• 5ch Stereo: Stereo via all channels (upmix)
• Dolby PLII Music: Dolby ProLogic II for music
• Dolby PLII Movie: Dolby ProLogic II for movies