Installation Manual

page | 11

Mounting in a Strong VersaBox

Using the provided screws, attach the amplifier to the VersaBox plate at the

circled mount points. (14x14” VersaBox shown)

CONNECTING NETWORK AND POWER

This device is designed to operate as part of the home system, which requires

physical audio connections and connections in Composer Pro to function as

designed. This section describes how to set up the physical connections required

for the amplifier and some devices associated with it.

WARNING! Connecting speaker wires or input cables while the amplifier is

powered may cause electrical shock and could damage the amplifier. Unplug the

amplifier and some of the devices associated with it.

To connect the amplifier to NETWORK and power ports:

1. Connect an Ethernet Cat 5e/6 cable from a local network connection into the

RJ45 port.

2. Connect the provided power cable to the amplifier’s power input and to a

power outlet.

3. When the power cable is first connected, the amplifier initially turns on in

Standby mode. Press the front-panel power button to fully power up.

FRONT PANEL

REAR PANEL

270 mm (10.63”)

211 mm (8.31”)