Installation Manual

Step 2a For ABPLUG3 & ABPLUG4:

Remove slide holder assembly

and the internal gasket.

Disconnect power and

communications devices and

remove flange.

Step 3a For ABPLUG3 & ABPLUG4:

Remove poke-thru unit from hole.

Step 4 Push in proper abandonment plug.

For 3" core hole, use ABPLUG3

For 4" core hole, use ABPLUG4

For 6" core hole, use ABPLUG6

For 8" core hole, use ABPLUG8

Step 5 Installation complete.

Step 2b For ABPLUG6 & ABPLUG8: Remove cover

assembly from Poke-Thru by removing two

(2) 8-32 screws and lifting cover off.

Step 3b For ABPLUG6 & ABPLUG8: Remove poke-thru

unit from floor by bending tabs inward and

pulling unit up.

WIREMOLD

U.S. and International:

60 Woodlawn Street • West Hartford, CT 06110

1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251

Canada:

570 Applewood Crescent • Vaughan, Ontario L4K 4B4

1-800-723-5175 • FAX 905-738-9721

1 002 048R4 0112

Step 1 Locate poke-thru unit or core hole

that needs to be sealed with an

abandonment plug.

ABANDONMENT INSTRUCTIONS – for use when the poke-thru unit is removed from the floor.

Covers all 3", 4", 6" and 8" poke-thru devices