Installation Guide

PLUGMOLD

PLUG-IN UNITS

I N S T A L L A T I O N I N S T R U C T I O N S

WARNING: For maximum safety, Plugmold Plug-In Units are

equipped with a grounding type plug (3-prong) for use

only with grounding type receptacles. Modification of

the plug to allow its use in non-grounding receptacles

voids the warranty and may lead to electrical shock.

1. Determine the installation location and rotate the

Plugmold Plug-In Unit to the necessary orientation

as follows:

a. Loosen the 2 phillips head screws near the plug

blades. Do not fully remove the screws.

b. Pull the rotating section of the plug outwards and

rotate to the desired orientation. The Plugmold

Plug-In Unit will rotate in 90° increments only.

c. Push in the rotating section of the plug and tighten

the 2 phillips head screws.

2. Plug the Plugmold Plug-In Unit into the desired

receptacle, hold securely, and mark the wall on top

and bottom of the Plugmold Plug-In Unit where the

mounting clips will be installed.

INSTALLATION:

Legrand/Wiremold electrical systems conform to and should be

properly grounded in compliance with requirements of the current

National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if

improperly installed or used. Legrand/Wiremold electrical products

may bear the mark of a Nationally Recognized Testing Laboratory

(NRTL) and should be installed in conformance with current local

and/or the National Electrical Code.

PAGE 1
PLUGMOLD® PLUG-IN UNITS I N S TA L L AT I O N I N S T R U C T I O N S WARNING: For maximum safety, Plugmold Plug-In Units are equipped with a grounding type plug (3-prong) for use only with grounding type receptacles. Modification of the plug to allow its use in non-grounding receptacles voids the warranty and may lead to electrical shock.
PAGE 2
INSTALLATION (continued): 3. Unplug the Plugmold Plug-In Unit and install the mounting clips on the wall. IMPORTANT – if the flat head screws furnished are not used, the substitute fasteners must also be of the flat head type, or the unit will not seat securely in the mounting clips. 4. Plug the Plugmold Plug-In Unit into the receptacle and snap into the mounting clips. WIREMOLD U.S. and International: 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • FAX 860-232-2062 • Outside U.S.