Installation Manual

Step 5. Orientation of receptacle shell. Step 6. Conduit connection. Step 7. Cut carpet to allow

for service fitting.

Use template on last page to

cut carpet for stem installation.

Tile Applications: Using a 2" [51mm]

diameter hole saw, drill an opening

concentric with the hole previously

IMPORTANT: Orientation of receptacle shell After installation, place the sleeve into the drilled into the tile.

critical during initial alignment. two tabs and rotate down. Replace screws

Make sure to orient the power to tighten sleeve.

side of poke-thru device facing

wires to be installed. Poke-thru

device cannot be rotated

after insertion into hole.

Installing Service Heads

and Faceplates:

Step 1. Remove screws and Step 2. Connect base to poke- Step 3. Connect communications

disposable cover. thru device. inserts and outlets.

NOTE: If base contains either all power

or all communications, the divider

plate may be removed. Otherwise,

the divider must remain in place.

Attach base to poke-thru stem as

shown. Make sure gasket seats

to floor when tightening.

Bases sold separately.

Push Down

Disposable Cover

(To Be Removed

at a Later Time)

Flooring

Tile or Carpet

200 Series

Divider Plate

241 Series