Cut Sheet

6
F
EATURES STANDARD OPTIONS
Communication Devices Ortronics or Pass & Seymour Other manufacturers
Activate Connectivity System Devices
Electrical Devices Pass & Seymour Other manufacturers and some In ter na tion al devices
Base Length Longest = 10' [2.54m], shortest = 1' [305mm] —
Installation Surface mounted Downward Facing Activations; Front Facing Activations
Finish Baked enamel finish – Designer colors Custom colors
Wire Type THHN stranded Options per specification
Wiring Splices Insulation displacement connectors Continuous wiring or twist-on wire connector
Grounding Conductors Wire gauge per National Electrical Oversized and/or separate grounding wires
Code (NEC) and shared grounding wires
Device Identification Gray self-adhesive polyester label Self-adhesive engraved nameplate
with black letters
Neutrals Shared neutral Oversized and/or separate neutral wires
Pigtails 12" [305mm] feeds and receptacle leads Per specification
Conduit Feeds Raceway drilled at job site Entrance end cap
Record Drawings 3 sets and 2 copies of marked-up blueprints Per job requirements
Submittal Services Detailed submittal Submittal free
DS4000 Series Raceway Prewired Raceway Features
Device and Raceway Labeling Detail for Prewired Applications
DS4000 Series Raceway Prewired Downward Device Options
n Device labeling is available in the following materials:
Gray self-adhesive polyester label with black lettering (stan dard).
Other color self-adhesive polyester labels.
Engraved phenolic nameplates with adhesive back ing.
n The back of the raceway is labeled with the raceway number and the room or area number(s).
Labeling detail using the front activation plates.
Labeling detail using the downward facing activation plates.
DS4000 Series Raceway Ordering Specifications for Prewired Applications
1. Detailed Submittal The detailed submittal will show exactly how each raceway run will be built including lengths, number
and type of receptacles, wiring schematics, circuiting information, etc. The contractor and/or distributor
must review, clarify any information not clearly indicated on the drawings or specs, approve, and return
to the factory before production can begin.
2. Submittal Free The Prewired Express Building Plan Checklist is filled out by the contractor or distributor and sent along
with plans, casework, and specs to the factory. No submittal is required and the project is scheduled for
production upon receipt of all necessary information.
Two options available when ordering a prewired job:
Flush downward facing power and data are available in the following single or multi-circuit 20A configurations:
DATA
16" or 24"
[ 406mm or 610mm]
on center
POWER
NOTE: Top channel Should be reserved for data to provide highest capacity and bend radius. Standard forward facing
faceplates can be intermixed with prewired, but are subject to location restrictions due to the location of
downward facing data. Consult factory for recommended locations.