Cut Sheet

Catalog No./Item Description/Specifications
RC4SHTCBK2CR
Poke-Thru Controlled Receptacle –
RC4SHTCBS2CR Nonmetallic Slide Holder Assembly
RC4SHTCGY2CR with Controlled Receptacle
RC4SHTCAA2CR Markings. Markings are located
RC4SHTCVY2CR in a recess pad and are permanent
indicating the duplex receptacle
below has been wired up to
comply with 2014 NEC
®
, CA Title
24 and ASHRAE Energy Efficiency
Standard 90.1. Available in,
black (BK) brass (BS), gray (GY),
aluminum (AA) and. ivory (VY). On
circuit “A” duplex receptacles are
controlled. Slide holder to be used
with the RC4ATC & RC4CTC units.
RC4SHTCBK4CR
Poke-Thru Controlled Receptacle –
RC4SHTCBS4CR Nonmetallic Slide Holder Assembly
RC4SHTCGY4CR with Controlled Receptacle
RC4SHTCAA4CR Markings. Markings are located in
RC4SHTCVY4CR a recess pad and are permanent
indicating both of the duplex
receptacles below have been wired
up to comply with 2014 NEC
®
,
CA Title 24 and ASHRAE Energy
Efficiency Standard 90.1. Available
in black (BK), brass (BS), gray (GY),
aluminum (AA) and. ivory (VY).
Both circuit duplex receptacles are
controlled. Slide holder to be used
with the RC4ATC & RC4CTC units.
RC4APTCBK Abandonment Plate – Available in
RC4APTCGY black (BK), gray (GY), painted
RC4APTCAB brass (AB), and ivory (VY).
RC4APTCVY
11
Catalog No./Item Description/Specifications
RC4REC2 Replacement Receptacle – Two
RC4REC2-25 prewired 20A duplex receptacles
can be wired as standard duplex
or isolated ground. Available only
in black. See installation instructions
with replacement receptacle for
complete installation details.
RC4REC2-25 is available with
25 foot leads and can be wired as
standard duplex or isolated ground.
ABPLUG4 Abandonment Plug Assembly –
Complete plug assembly for
abandoning an open 4" (102mm)
cored-hole. Assembly includes
intumescent fire-stop material to
maintain the fire-classification of
the floor, integral retainer ring to
prevent the unit from pulling up
through the floor, and a black
die-cast aluminum cover.
COM50 Communication Adapter –
COM75 For two 1/2" trade size conduit
connections (COM50). For two
3/4" trade size conduit
connections (COM75).
NOTE: The 20A duplex receptacle
supplied with the scrub
water version RC4 Poke-Thru
Device is proprietary and can
only be replaced with the
RC4REC2 or RC4REC2-25.
7 1/2"
(191mm)
3 7/8"
(98mm)
RC4 Series Ordering Information (Continued)
NOTE: See page 3 for specifications.
6 1/4"
(159mm)
NOTE: To abandon the RC4 Series
Poke-Thru Device, the internal
gasket, duplex receptacle, and
communication modules must
not be removed in order to
maintain UL Classification. Also
the stem must remain in the
core-drilled hole.
NOTE: No additional capacity
with COM75.
4" HOLE SIZE POKETHRU DEVICES
CAUTION: Not intended for use
on polished concrete
or terrazzo floor
applications.