Operating instructions

WirelessHART Fieldgate SWG70 10 Engineering

Endress+Hauser 69

Input Register parameters

Parameter Meaning Example Default

Table

– For Input Register the first value is normally 30000; some

systems work only with Holding Registers starting at 40000

– The intial value can be overwritten only after a device has been

selected in the Long Tag drop-down menu

– Subsequent start registers are automatically generated

13 1

End Register End register for HART device values (generated automatically) 14 65531

Long Tag Click to open a drop-down list of connected network devices – –

IO-Card Identifier of fieldgate card used by the device – –

Channel Identifier of card channel used by the device – –

Value Click to open a drop-down list of values for the selected device – –

Delete button Depending upon position, deletes the table or the table line

Generate

Start Register Defines the start register for the first HART device

– For Input Registers this is normally 1, depending on the Modbus

system in use

13 1

Generation Order Order in which the devices are mapped to the Modbus registers.

• Index: According to the index number, see Instrument List,

Chapter 10.1, for example

• Alphabetical: In alphabetical order according to the Long Tag

• Alphabetical (sub-device): In alphabetical order according to the

Long Tag of the sub-device.

• IO card & channel: According to the IO card & channel number

of the wireless device.

• IO card & channel (sub-device): According to the IO card &

channel number of the sub-device.

Value Click to open a drop-down list of values for the selected device

Delete button Depending upon position, deletes the table or the table line

Default Settings Adds all HART Command 3 values to the value list, see Appendix A

Generate Writes mapping table to table in Table tab

Delete all mappings • Checked: Overwrites any table already in Table tab

• Unchecked: Adds any new devices found to existing table

Controls

Import Imports a mapping table in CSV format

Export Exports the current mapping table in CSV format

Refresh Loads the mapping table currently stored in Fieldgate SWG70

Apply Stores the current mapping table to Fieldgate SWG70