Operating instructions

7 Commissioning WirelessHART Fieldgate SWG70
40 Endress+Hauser
7.6 User interface
The Web Server and DTM of the Fieldgate SWG70 are structured in the same manner, so that the
configuration is identical. Before starting, the Web Server must be open, see Chapter 7.2.2 or the
Online parameterization dialog of the DTM must be open, see Chapter 7.5.3. The user interface
is structured as follows:
The Web interface differs from the DTM only in the presentation of the parameters. In the case of
the Web interface, the parameters are presented in a single tree. For the DTM, the Parameterization,
Diagnostics and Additional Functions are contained in separate DTM dialogs, which must be called
by a right-click on the Fieldgate SWG70 node and selection from the context menu. The DTM offers
addition functions which are FDT-frame specific, e.g. Set Device Addresses. In both cases
parameters are registered by pressing Enter. In some cases, in which more than one parameter is
registered, an additional button must be pressed for the changes to take effect.
Parameters (DTM dialog: Online Parameterization) Chapter 8
Identification Chapter 8.1
Wireless Communication Chapter 8.2
Setup (Basic/Advanced) Chapter 8.2.1/2
Operating modes Chapter 8.2.3
Wired Communication Chapter 8.3
Interfaces –
Serial Chapter 8.3.1
Ethernet Chapter 8.3.2
Protocols –
HART Chapter 8.3.3
Modbus Chapter 8.3.4
AMS Chapter 8.3.5
Diagnosis (DTM dialog: Diagnostics) Chapter 9
Identification Chapter 9.1
Wireless Communication Chapter 9.2
Overview Chapter 9.2.1
Details Chapter 9.2.2
Burst Lists Chapter 9.2.3
Topology View Chapter 9.2.4
Wired Communication Chapter 9.3
Overview Chapter 9.3.1
HART Chapter 9.3.2
Engineering Chapter 10
Instrument List Chapter 10.1
General Chapter 10.1.1
Creation and editing of an instrument list Chapter 10.1.2
Modbus Mapping Chapter 10.2
Modbus Settings Chapter 10.2.1
Input Status Chapter 10.2.2
Input Register Chapter 10.2.3
Topology View Chapter 10.3
Additional Functions (DTM dialog: Additional Functions => Function) Chapter 11
Reset Chapter 11.1
Self Test (DTM only) Chapter 11.2
About Chapter 11.3
Firmware Update Chapter 11.4
Change Password Chapter 11.5
Set DTM Addresses (DTM only) Chapter 11.6
Set Device Addresses (DTM only) Chapter 11.7
Upload Certificate (Web server only) Chapter 11.8
Measurement Chapter 12