Operating instructions

WirelessHART Fieldgate SWG70 7 Commissioning
Endress+Hauser 33
7.4 Installing FieldCare
If you do not already have FieldCare running on your computer, you can install FieldCare Device
Setup from the corresponding DVD: will normally start automatically, otherwise via setup.exe.
7.4.1 Installing the Fieldgate DTM and HART IP CommDTM
1 Insert the Fieldgate CD ROM into the CD ROM drive: the setup program starts:
– If this is not the case, double click on Setup.exe to be found in the Fieldgate SWG70 folder
2 Click on WirelessHART Fieldgate DTM: the DTM Setup Wizard starts:
–Press Next to continue
3The Licence Agreement dialog appears: read and accept it, then press Next to continue
– If you do not accept the licence agreement, the wizard closes
4In the Customer Information dialog, enter details of the user, then press Next to continue
5In the Choose Setup Type dialog, select Complete
– If the wizard has found an earlier version of the DTM, press Upgrade
6 DTM Setup Wizard now locates the FieldCare HART DTM folder and displays it in the
Ready to Install dialog: press Install to start installation
– A progress bar indicates the state of installation
7 When installation is complete the successfully installed dialog appears:
–Press Finish to close the dialog and finish the installation
8 Repeat the procedure for the HART IP Communication DTM
9 If you intend to use the HART OPC server you can also install it in approximately the same
manner from the HART OPC Server menu item
10 Press "X" in the Setup Welcome dialog to close the setup program