Operating instructions

WirelessHART Fieldgate SWG70 4 Mechanical Installation

Endress+Hauser 19

4.3 Mounting the Fieldgate

In addition to fulfilling the conditions for good wireless communication, the mounting location

should be well accessible for mounting and electrical installation. Make sure that there is enough

space to open the housing cover and to access the terminals, switches, and cable glands. Choose a

mounting location that meets the climatic limits specified and radio requirements in the technical

data.

The housing has a degree of protection of IP65 and is designed for wall mounting (mounting

accessories not included).

Required tools:

• 2 screws (M6)

• Drill

• Screwdriver

Fig. 4-7: Mounting holes and housing screws

Mounting the Gateway 1 Drill 2 holes in the mounting surface so that they match the holes of the housing

(centres 240 mm to 250 mm apart). See Chapter 15.5 for dimensioned drawing.

2 Screw the device to the mounting surface.

1 Mounting holes 2 Housing screws

1 1