Operating instructions

WirelessHART Fieldgate SWG70 C Appendix: HART OPC Connection
Endress+Hauser 109
4 Press the Device tab to open the Device dialog
This contains information on the tagging and range of the device
– Gray fields are parameters loaded from the device memory
– White fields can be edited, to store changes, press Send
5 The significance of the parameters can be taken from the table below
Device parameters
Parameter Meaning
Device Info
Message User message, transmitted with information from the device – up to 32 characters
Tag String identifying the device - up to 8 characters if "Use Start Tag" is ticked, otherwise 32
Descriptor Additional user text describing, e.g. function or location of device – up to 16 characters
Date Indicates the date
Final Assembly Number Indicates assembly number of device
Write Protect Indicates whether write protect is in operation
Private Label Distributer Indicates label of a private distributor
Sensor Serial Number Indicates sensor serial number
Sensor Info
Upper Sensor Limit Indicates maximum value of the process variable that can be measured by the device
Lower Sensor Limit Indicates minimum value of the process variable that can be measured by the device
Minimum Span Indicates minimum span that can be set at the device
Standard Procedures
Self Test Press to initiate self-test of device
Loop Test Press to initiate test of loop to which the device is connected
Master Reset Press to reset the device and restore all factory settings
DAC Trim Trims the loop (DAC = Digital to Analog Converter)