Specifications

Page 22
WT1231H
Pout on PA0 [dB m ]
Pout on PA1 [dB m ]
Pout on PA1+PA2 [dBm]
P out on P A 1+ P A 2 wit h 20dB m s ettings [dB m ]
Pout
[dBm]
3.3.7. High Power Settings
The WT1231H has a high power +20 dBm capability on PA_BOOST pin, with the following
s
ettings: Table 11 High Power Settings
Register Address
Value for
High Power
Value for Rx
or PA0 use
Description
RegOcp
0x13 0x0F 0x1x
OCP control
RegTestPa1
0x5A 0x5D 0x55
High power PA control
RegTestPa2
0x5C 0x7C 0x70
High power PA control
Note
High Power settings
MUST be turned off when using PA0, and in Receive mode
The
Duty Cycle of transmission at +20dBm is limited to 1%, with a maximum VSWR of 3:1 at antenna port, over the
standard operating range [-40;+85°C].
3.3.8. Output Power Summary
The curves below summarize the possible PA options on the WT1231H:
P o ut vs. P r o g ram m ed P o w er
22
18
14
10
6
2
-2
-6
-10
-14
-18
-22
-18 -14 -10 -6 -2 2 6 10 14 18
Pr o g r am m e d Po w e r [d Bm ]
Figure 6. Output Power Curves
3.3.9. Over Current Protection
An over current protection block is built-in the module. It helps preventing surge currents required when the transmitter is
used at its highest power levels, thus protecting the battery that may power the application. The current clamping value is
controlled by OcpTrim bits in RegOcp, and is calculated with the following formula:
Imax = 45 + 5 ⋅ OcpTrim  mA 
Note Imax sets a limit on the current drain of the Power Amplifier only, hence the maximum current drain of the
WT1231H is equal to Imax + I
FS