Installation Manual

vii
CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)
Rev A1
Document:
WSS 4G Ground Installation Manual 750-
00004-00 Reva1.Docx
July -30
2020
LIST OF ILLUSTRATIONS
Figure Title Page
Figure 1.4-1 Shock Sensors .................................................................................... 3
Figure 1.6-1 System Interfaces/Overview ................................................................ 6
Figure 2.3.1-1 Aircraft Base Radio Form Factor ....................................................... 13
Figure 2.3.1-2 Installation Tray ................................................................................. 14
Figure 2.3.2-1 High Performance Blade (HPB) Antenna Detail (Rear Mount) .......... 15
Figure 2.3.2-2 High Performance Blade (HPB) Antenna Detail (Front Mount) .......... 16
Figure 2.3.2-3 Full-Duplex Quad (FDQ) Tx/Rx Blade Antenna Detail ....................... 17
Figure 3.4-1 TNC Connector Tool ......................................................................... 22
Figure 3.4-2 Insertion Tool .................................................................................... 22
Figure 3.4-3 Extraction Tool .................................................................................. 22
Figure 3.5.1-1 Typical Antenna Mounting ................................................................. 23
Figure 3.5.1-2 Antenna Location Preferences – Learjet 45 Example ....................... 25
Figure 3.5.1-3 Antenna Location Preferences – Citation Sovereign Example .......... 25
Figure 3.5.1-4 Antenna Off-Centerline Mounting ...................................................... 26
Figure 3.5.1-5 Antenna Off-Centerline Tilt ................................................................ 26
Figure 3.5.1-6 FDQ Fore-Aft Tilt ............................................................................... 27
Figure 3.5.1-7 HPB Fore-Aft Tilt ............................................................................... 27
Figure 3.5.1-8 HPB and FDQ Antenna Separation ................................................... 27
Figure 3.5.1.2-2 HPB Separation Placement Considerations ...................................... 28
Figure 3.6.3.1-1 Example 2-pair Twisted, Shielded Cable ........................................... 31
Figure 3.6.3.2-1 Example 1000BASE-T Ethernet Cable .............................................. 31
Figure 5.1.1-2 Aircraft Base Radio Front Panel View ............................................... 40
Figure 5.1.1-2 Aircraft Base Radio Connector Pin Definition Chart .......................... 41
Figure 5.1.2-1 RRH to Antennas Connectivity .......................................................... 43
Figure 5.1.3-1 RRH Power and Ethernet Connectivity ............................................. 44
Figure 5.1.3-2 RRH to Antenna Power and Control Connectivity ............................. 45
Figure 5.2.1-1 P1-A Shield Terminations.................................................................. 46
Figure 5.2.2-1 P1-B Shield Terminations.................................................................. 48
Figure 5.2.3-1 RRH P2-A Shield Terminations ......................................................... 49
Figure 5.2.4-1 FDQ P1 and HPB P1Shield Terminations ......................................... 51
Figure 5.2.5-1 P2-C and P2-D Shield Terminations ................................................. 52
Figure 7.2.2-1 RRH Front Panel Indicators .............................................................. 65
Figure 7.2.2-2 RHH Front Panel ............................................................................... 65