Installation Manual

23
CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)
Rev A1
Document:
WSS 4G Ground Installation Manual 750-
00004-00 Reva1.Docx
July -30
2020
3.4
Special Tooling
3.4.1
Installation Tools
An optional special tool is recommended to mate and de-mate the TNC connectors on
the front panel of the ABR chassis, as these connectors are tightly spaced. The tool is
an Ideal Industries Tool, Connector Removal; BNC/TNC; 12-inch, Mfr. Part#: 35-042,
or equivalent, as depicted in Figure 3.4-1.
For the assembly of the DMC connector, the following tools are required; a) Insertion
Tool (long Version) 057-0699-00A/(EN4165TS), and b) Extraction Tool (long Version)
057-0289 A/(EN4165TN). These are not pin insertion tools but module insertion and
extraction tools. They are depicted in Figure 3.4-2 and Figure 3.4-3, for the Insertion
and Extraction, respectively. Additionally, a 3mm hexagonal screwdriver is needed for
securing the DMC connectors to the ABR.
Figure 3.4-1 TNC Connector Tool
Figure 3.4-2 Insertion Tool
Figure 3.4-3 Extraction Tool