Installation Manual

CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)

Rev A1

Document:

WSS 4G Aircraft Installation Manual 750-

00003-00 Reva1.Docx

July -30

2020

an Ideal Industries Tool, Connector Removal; BNC/TNC; 12-inch, Mfr. Part#: 35-042,

or equivalent, as depicted in Figure 3.4-1.

For the assembly of the DMC connector, the following tools are required; a) Insertion

Tool (long Version) 057-0699-00A/(EN4165TS), and b) Extraction Tool (long Version)

057-0289 A/(EN4165TN). These are not pin insertion tools but module insertion and

extraction tools. They are depicted in Figure 3.4-2 and Figure 3.4-3, for the Insertion

and Extraction, respectively. Additionally, a 3mm hexagonal screwdriver is needed for

securing the DMC connectors to the ABR.

Figure 3.4-1 TNC Connector Tool

Figure 3.4-2 Insertion Tool

Figure 3.4-3 Extraction Tool