Installation Manual

20
CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)
Rev A1
Document:
WSS 4G Aircraft Installation Manual 750-
00003-00 Reva1.Docx
July -30
2020
WHILE THE ABR SYSTEM IS NOT CLASSIFIED AS A STATIC
SENSITIVE DEVICE, GOOD SHOP PRACTICES SHOULD BE
FOLLOWED WHEN HANDLING AND INSTALLING ALL
EQUIPMENT. USE OF GROUNDED CONDUCTIVE SURFACES
AND ANTISTATIC MATERIALS IS RECOMMENDED.
THE FOLLOWING PRECAUTIONS SHOULD BE FOLLOWED WHILE INSTALLING
THE 001-00300-10:
• De-energize or disconnect all power and signal sources and loads before
installing the 001-00300-10.
• Place the component on a grounded, conductive surface.
• Ground the installer through a conductive wrist strap or other device using a
470-kilohm or 1-megohm series resistor to protect the equipment.
• Ground any electrical tools, such as soldering equipment that will contact the
component. Contact with the operator’s hand provides sufficient ground for
tools that are otherwise electrically isolated.
• Install cables away from power outlets, uninterruptible power supplies, and other
sources of strong electromagnetic interference.
• Ensure adequate shielding or protection is included if aircraft radio is installed
where it may come in contact with fluids.
The ABR does not contain any user-serviceable parts. Unauthorized modifications or
repairs could result in permanent damage to the 001-00300-10, void warranty and
authority to operate this device under FAA, FCC and other applicable regulations.
Repairs may only be performed by authorized service centers.